0

Kerf X -10 - Rob Cosman
Creating half-blind dovetails just got a little easier with the Rob Cosman Kerf X-10. This Kerf Extender creates a clean edge on each side of your half-blind dovetails saving you cleanup with your chisel after the cut.
$167.50
$155.50
You Save $12.00
Qty
Enter your e-mail address to be notified when product is in stock
Notify Me!
Product Description
"Back in the summer of 1987 I had the great fortune of working with Tage Frid. Tage showed me his method of finishing the saw cuts on the pin board of a half blind dovetail. This joint only allows the dovetail saw to be used between the marking gauge lines, leaving half the cut to be carved with chisels. By using the Kerf X-10 as shown in the video, the saw cut is completed and the process of waste removal is sped up and done more accurately"  - Rob Cosman

Fast Facts;
  • Saw plate is 0.635mm (0.025” )
  • Handle is mahogany 
  • Blade is held in the 6.35mm x 19mm (¼” by ¾”) brass back with peened copper pins 
  • Brass back is secured in the handle with a 38mm x 6.35mm x 6.35mm (1 1/2” by ¼” by ¼”) tenon secured with a copper pin and epoxy 
  • Blade is sharpened square to the sides and ready for use
  • Overall length is 185mm (7”), blade length 70mm, 19mm depth (2 ¾”, depth ¾”) 
Reviews (0)
Currently there are no reviews for this product.
Questions
Currently there are no questions for this product.