Variable Pressure Featherboards Combo Value Pack by Woodpeckers
2 pairs of Variable Pressure Featherboards
4 Mitre Slot Nuts
Using this combination, you will be able to employ 2 downward acting and 2 horizontal acting Featherboards on you router table, table saw etc. Using the standard 19mm x 10mm Mitre Channel supplied with your router table and the standard T Track fitted to your router fence. This configuration will ensure safety and accuracy.
Featherboards are an invaluable tool to control stock when routing, shaping, ripping and resawing. When properly installed, the featherboard should keep your work piece against the guide fence, down on the table and should reduce the possibility of dangerous kick-back.
One important part of proper installation is setting its position just right for effective pressure. Up until now that required trial-and-error positioning of the featherboard. Each time knobs have to be loosened and the device adjusted and then try it one more time. It isn't unusual to have to repeat this process two or three times to get the pressure just right.
Not anymore! Woodpeckers Variable Pressure Featherboard has a built in adjustment plate that increases or reduces holding pressure with a very simple adjustment. There's absolutely no need to change the featherboard's position to change the pressure.
This new American made featherboard is designed for any application that requires control of wood position as it's being fed along a fence or on a table. It can attach to any 1/4" T-track, as is included with the Woodpecker RF3 and SuperFENCE fences, with the standard included hardware.
Woodpeckers new Variable Pressure Featherboard is the first featherboard whose pressure can be adjusted without moving the featherboard.
Made in OHIO, U.S.A.